VQ1015 R2 Firmware is available to download.
Follow the simple directions below! With this firmware, you can take very unique photos including photos in black and white or vivid photos.
Warning!: This firmware is for VQ1015 R2 only. If it was used with other models, it might cause a malfunction and damage.


| To enjoy 8 different shutter speeds |
VQ1015 R2 0522 Firmware
|
 |
※After you install this firmware, changing the shutter speed will be the only function you can use.
|
※Some browsers have trouble downloading the firmware. In that case, please try again with other browsers.
※The firmware cannot be replaced while SD card is kept inserted into the camera. Please take out SD card before you start to download regardless of the model with or without built-in memory.
※When replacing firmware, please take full responsibility for your own actions. We are not responsible for any defects or malfunction due to the replacement.
※The firmware is a zip file. If you don’t have a decompression utility installed on your computer, please obtain an appropriate utility to accommodate your computer through the Internet.

Please use a new battery.
If the battery runs out in the middle of the download, it might cause a malfunction and damage your camera.

Make sure the “100 IMAGE” folder is empty.
In case you have images in the folder, save them in a different location and make the folder empty.






You may disconnect the usb cable from the camera and computer without closing the “100IMAGE” folder or using the “safely remove hardware” function.
※Please repeat above the installation from step 1 if you don’t hear the beep sound.