Sunday, Feb 05th

Last update12:48:55 AM GMT

Japanese(JP)English (United Kingdom)简体中文(中国)
You are here: Firmware

VQ1015ENTRY Firmware is available to download.
Follow the simple directions below! With this firmware, you can take very unique photos including photos in black and white or vivid photos.
Warning!: This firmware is for VQ1015 ENTRY only. If it was used with other models, it might cause a malfunction and damage.

Software License Agreement

Download the Firmware

Default firmware
VQ1015 ENTRY 0727 Firmware For the model with built-in memory Download Button
For the model without built-in memory Download Button
For taking photos in black and white
VQ1015 ENTRY 0612 Firmware For the model with built-in memory Download Button
For the model without built-in memory Donwload Button
For 1120 x 1024 photos/movies with color modes (Still image: Color, B&W, and Sepia; Movie: Sepia and B&W).
VQ1015 ENTRY 0906 Firmware For the model without built-in memory Download

※The firmware cannot be replaced while SD card is kept inserted into the camera. Please take out SD card before you start to download regardless of the model with or without built-in memory.

※When replacing firmware, please take full responsibility for your own actions. We are not responsible for any defects or malfunction due to the replacement.

※The firmware of VQ1015 ENTRY without built-in memory is a different type of that of the model with built-in memory. Using a mismatched firmware might cause a malfunction and damage your camera.

※The firmware is a zip file. If you don’t have a decompression utility installed on your computer, please obtain an appropriate utility to accommodate your computer through the Internet.

connect your vq1015 Entry with your computer via USB

Please use a new battery.

If the battery runs out in the middle of the download, it might cause a malfunction and damage your camera.

Check the "100IMAGE" folder for VQ1015 ENTRY

Make sure the “100 IMAGE” folder is empty. In case you have images in the folder, save them in a different location and make the folder empty.

Move the firmware you downloaded into the "100Image" folder.

Make sure the firmware is in the "100IMAGE" folder.

Disconnect the USB cable fro m the camera and computer.  When you hear the beep, the donload is completed.

You may disconnect the usb cable from the camera and computer without closing the “100IMAGE” folder or using the “safely remove hardware” function. 
The beep sound might be subtle. Please listen carefully.

※Please repeat above the installation from step 1 if you don’t hear the beep sound.